Single row tapered roller bearings
Taper roller bearings can take both axial and radial loads. The axial load carrying capacity of the bearings is largely determined by the contact angle α as shown in the figure below. If the contact angle α is larger, then the axial load carrying capacity is higher and vice versa.
Taper roller bearings are designed in such a way that vertices of the cone for each roller and those for the inner and outer raceways coincides on the bearing axis or extensions of the raceways and rollers converge at a common point on the axis of rotation. This results in true rolling motion of the rollers on the raceways at every point along the rollers. The taper roller bearings support radial loads and axial loads from one direction only. The line contact between rollers and raceways provide the bearings with a high load carrying capacity.
Steep angle taper roller bearing with exceptionally steep cone angle enables the bearings to take heavier axial load. The bearings are of separable type, enabling separate mounting of cups and cones.
Since the taper roller bearings can absorb thrust loads in one direction only, these bearings should generally be installed as opposed mountings. The correct amount of radial and axial clearance is obtained by adjusting the two bearings against each other.
- SNR 32208A Single row tapered roller bearings
- 2.00 mm
- 2600 rpm
- 35 mm x 72 mm x 23 mm SNR 32207.C Single row tapered roller bearings
- 711.2 mm
- 1 1/8-7 UNC
- 35 mm x 72 mm x 23 mm SNR 32207.B Single row tapered roller bearings
- 2520 lbf
- 0.4531 in
- 30 mm x 62 mm x 20 mm SNR 32206.C Single row tapered roller bearings
- 25 N/mm²
- 0.5 m/s
- 320 mm x 480 mm x 100 mm NTN 32064XU Single row tapered roller bearings
- Shield & Seal
- 1.00 mm
- 280 mm x 420 mm x 87 mm NTN 32056XU Single row tapered roller bearings
- 342.9 mm
- 22318 EK
- 240 mm x 360 mm x 76 mm NTN 32048XU Single row tapered roller bearings
- 2400 rpm
- 124000 N